Three ways to implement SMED (Single Minute Exchange of Die) in Injection Molding Operations.
smartflow products designed for smed process
Manufacturing Engineers strive to reduce setup times and maximize machine run times, increasing profits. Setup times are reduced by converting internal operations (done when the press is idle) to external operations (done while the press is running). Additionally, setup times are reduced by using the proper tools to decrease the time required by internal operations.
1.
duoflow manifolds
Duoflow Manifolds convert an internal operation to an external operation by connecting all cooling water lines to a mold-mounted cooling water manifold. Reduce water hook-up to seconds by using one connection for Supply Water and one connection for Return Water with quick disconnect fittings on the ends.
2.
swap valves
Swap Valves reduce time required for cooling line evacuation between mold changes to seconds instead of minutes while keeping shop floors clean. SWAP valves use shop air to evacuate fluid from cooling lines with a single handle motion. The mold can then be changed. Resume main cooling fluid supply with the reverse handle motion.
3.
fastie quick ejector tie-in
Fastie Ejectors slashes knockout connection time to seconds with quick couplers and studs. FasTie couplers reside in the press ejector plate. FasTie studs are fastened to each mold in storage. When a mold change is performed, ejector tie-in is literally a snap.
Ready to chat about your SMED needs?
Give AceTronic a call to discuss everything SMED.
